4-20MA to 5V Converter for Arduino Industrial Sensor Interface Board

You can interface your any microcontroller with Industrial Sensors and Devices with a 4-20mA output. Interfacing these devices with Arduino/Raspberry Pi has always been tough and complex due to the external circuits, tuning required to convert the current signal to an analog voltage. This board takes care of this and converts the 4-20mA(or 0-20ma) current signal to a 0-5V or 0-3.3V or 0-10V analog output voltage which can be directly connected to the ADC pin of the microcontroller. Connections are easy and simple with the onboard screw terminal connectors! Input Supply Voltage is 7-12V DC Current Input support 4-20Ma & 0-20mA voltage output support 0-3.3V 0-5V 0-10V Wide supply voltage range, the output has multiple voltage ranges High stability, good linearity, industrial grade Working Functions: The module HW-685 is wired as defined, and the power supply voltage is 12V DC. After power-up, the D2 indicator should be on, otherwise check the line connection. Board with reverse protection, reverse does not burn. When the current input is the minimum (0mA or 4mA), adjust the ZERO potentiometer so that the VOUT output is the minimum (0.0V or other voltage). When the current input is at maximum (20mA), adjust the SPAN potentiometer so that the VOUT output is the maximum (3.3V or 5V or 10V, the output can be as low as 2.5V when the input is 4-20ma). According to your needs, through the jumper cap to select the appropriate range: 4–20ma (Jumper Settings for Output Voltage Range Input Signal) 0-2.5V: J1 1,2 pin are short circuit connected; 3, 4 pin are short circuit connected 0-3.3V: J1 1,2 pin are disconnected; 3, 4 pin are disconnected 0-5V: J1 1,2 pin are short circuit connected; 3, 4 pin are short circuit connected 0-10V: J1 1,2 pin are short circuit connected; 3, 4 pin are disconnected 0–20ma (Jumper Settings for Output Voltage Range Input Signal) 0-3.3V: J1 1,2 pin are short circuit connected; 3, 4 pin are short circuit connected 0-5V: J1 1,2 pin are short circuit connected; 3, 4 pin are short circuit connected 0-10V: J1 1,2 pin are short circuit connected; 3, 4 pin are disconnected Package Includes: 1 x Current to Voltage Converter Module 0 / 4-20MA to 0-3.3V 5V 10V